AOS RC 5 Inch EVO 3D Printed TPU Accessories For FPV Frames

AOS RC 5 Inch EVO 3D Printed Accessories For Your Frame

AOS RC 5 inch EVO 3D printed accessories give your 5 inch build a flexible way to add protection and function. You choose each part on its own, so every piece on the quad earns its place. This control helps you manage weight while still guarding the spots that take the hardest hits.

You do not depend on a fixed kit that adds parts you never use. Instead, you select single prints that fit your camera, antenna plan, and electronics stack. The result feels custom, clean, and easy to service at the bench or at the field.

Pick Individual TPU Parts For Your 5 Inch EVO

Each accessory prints in tough TPU and sells as a separate item. You can build your own set from options like:

• FPV camera guard and shroud that shield the lens during front impacts

• Rear antenna mounts that hold VTX and receiver antennas at neat, repeatable angles

• Action camera base that suits common compact HD cameras for smooth flight footage

• VTX and receiver plates that stop boards from flexing or sliding in hard crashes

• Wire clips and strain relief pieces that keep leads away from props and sharp carbon edges

You might start with a camera guard, then add antenna or action cam mounts as your setup grows. The shared spacing and style help every new print line up with the parts you already use.

Built For Real FPV Spots And Rough Landings

A 5 inch EVO rig spends time in tight gaps, near trees, and around concrete. Crashes will happen, so these TPU parts move key components away from common strike zones. The prints flex on impact and often spare cameras, antennas, and wires from direct hits.

This layout suits fast freestyle, bando runs, and relaxed park cruising. You keep one trusted frame and adjust props, tune, and camera settings instead of building a fresh quad for every session.

Simple To Install And Ready For Upgrades

Install time stays short. Each print follows the AOS RC 5 inch EVO geometry, so holes line up and hardware fits without odd spacers. You bolt the part on, confirm clearance, and get back to flying.

When your gear changes, you only swap the pieces that no longer match. With the right mix of AOS RC 5 inch EVO 3D printed accessories you keep the same solid base frame while your electronics and layout evolve. Your quad remains neat, protected, and ready for the next pack.