AOS RC 5 Inch V5 3D Printed TPU Accessories For FPV Frames

AOS RC 5 Inch V5 3D Printed Accessories For Your Build

AOS RC 5 inch V5 3D printed accessories give your 5 inch frame a flexible way to add protection and function. You select each part on its own, so every piece on the quad has a clear job. This control helps you manage weight while you still shield the spots that take the hardest hits.

You do not rely on a fixed bundle that includes parts you never use. Instead, you choose single prints that match your camera, antenna plan, and electronics stack. The result feels clean, intentional, and easy to service at the field or on the bench.

Choose Individual TPU Parts For Your 5 Inch V5

Each accessory prints in tough TPU and sells as a separate item. You build your own setup from options like these.

• FPV camera guard and shroud that protect the lens during front impacts

• Rear antenna mounts that hold VTX and receiver antennas at neat, repeatable angles

• Action camera base that suits common compact HD cameras for smooth flight footage

• VTX and receiver plates that keep boards from sliding or flexing in hard crashes

• Wire clips and strain relief parts that guide leads away from props and sharp carbon edges

You can start with one camera guard, then add antenna or action cam mounts as your build evolves. Because the prints share a common spacing and style, new parts line up with the ones you already use.

Built For Real Spots And Heavy Sessions

A 5 inch V5 rig often dives gaps, skims concrete, and scrapes branches. Crashes will happen. These TPU parts move key components away from common strike zones and help soften many direct hits. Cameras stay straighter, antennas bend instead of snapping, and wires avoid constant cuts.

This layout works for fast freestyle, bando runs, and relaxed park cruising. You keep one trusted frame and adjust props, tune, and camera settings instead of building a new quad for every location.

Fast To Install And Easy To Update

Install time stays short. Each print follows the AOS RC 5 inch V5 geometry, so holes line up and hardware fits without odd spacers. You bolt the part on, check clearance, and get back to flying.

When your gear changes, you only replace the single prints that no longer match. With the right mix of AOS RC 5 inch V5 3D printed accessories you keep the same solid base frame while your electronics and layout grow with your skills. Your quad remains neat, protected, and ready for the next pack.