AOS RC 5.5 Inch EVO 3D Printed TPU Accessories For FPV Frames

AOS RC 5.5 Inch EVO 3D Printed Accessories For Your Build

AOS RC 5.5 inch EVO 3D printed accessories give your 5.5 inch frame a flexible way to add function and protection. You select each piece on its own, so every part on the quad has a clear job. This control helps you manage weight while you still cover the places that see the hardest hits.

You never have to buy a fixed bundle that adds parts you do not want. Instead, you choose single prints that suit your camera, antenna layout, and electronics stack. The result feels clean, intentional, and easy to work on at the bench or at the field.

Choose Individual TPU Parts For Your 5.5 Inch EVO

Every accessory prints in tough TPU and sells as a separate item. You build your own setup from options like these.

• FPV camera guard and shroud that protect the lens during direct front impacts

• Rear antenna mounts that hold VTX and receiver antennas at neat, repeatable angles

• Action camera base that fits common compact HD cameras for smooth flight footage

• VTX and receiver plates that keep boards from sliding or flexing during hard crashes

• Wire clips and strain relief parts that guide leads away from props and sharp carbon edges

You can start with one camera guard, then add antenna or action cam mounts as your build evolves. Shared spacing and a consistent style help new parts line up with the prints you already use.

Built For Real Spots And Rough Sessions

A 5.5 inch EVO rig often dives gaps, scrapes branches, and flies near concrete. Crashes will happen. These TPU pieces move key components away from common strike zones and help soften many direct hits. Cameras stay straighter, antennas bend instead of snapping, and wires avoid constant cuts.

This layout works for fast freestyle runs, bando flights, and long park cruises. You keep one trusted frame and adjust props, tune, and camera settings instead of building a fresh quad for every location.

Quick To Install And Easy To Upgrade

Install time stays short. Each print follows the AOS RC 5.5 inch EVO geometry, so holes line up and hardware fits without odd spacers. You bolt the part on, check clearance, and get back in the air.

When your gear changes, you only swap the single prints that no longer match. With the right mix of AOS RC 5.5 inch EVO 3D printed accessories you keep the same solid base frame while your electronics and layout grow with your skills. Your quad remains neat, protected, and ready for the next pack.