AOS 4 Inch EVO 3D Printed TPU Accessories For FPV Frames

Custom 3D Prints For Your 4 Inch EVO

AOS 4 inch EVO 3D printed accessories give your freestyle frame a clean and functional finish for real flying. You pick only the parts you need, so every piece on the quad earns its place. Each print helps protect key components, manage wires, or improve handling on the bench. You spend less time fixing damage and more time in the air.

You no longer rely on one fixed kit. Instead, you mix and match single parts that fit the AOS 4 inch EVO layout. This approach lets you keep weight under control and match the build to your exact camera, radio link, and flying style.

Choose The Parts Your Build Needs

Every accessory prints in flexible TPU and ships as a separate item. You select the mounts that match your setup:

• FPV camera guard and shroud that shield the lens in direct hits

• Rear antenna mounts that hold VTX and receiver antennas at repeatable angles

• Action camera base that suits popular small format HD cameras

• Compact plates for VTX and receiver boards that prevent flex and movement

• Wire clips and strain relief pieces that keep leads away from props and sharp carbon edges

You can start with a simple camera guard, then add antenna or action cam mounts later. The parts share a common style and spacing, so they still line up when you expand the build.

Built For Tight Lines And Hard Landings

A 4 inch quad often threads gaps and hits branches, concrete, or metal. These TPU parts move sensitive gear away from obvious strike zones and absorb many smaller impacts. Cameras stay straighter, antennas bend instead of snapping, and wires avoid constant cuts. The frame sees abuse, but the rest of the electronics have a better chance to survive.

The accessories suit aggressive freestyle, bando work, and smooth cruising. You do not need a second frame for a different style. Swap props or a camera and keep flying the same airframe.

Simple To Install And Easy To Change

Mounting stays quick. Each part follows the AOS 4 inch EVO geometry, so holes line up and hardware fits without odd spacers. You bolt the print on, route the wires, and check clearances with very little tuning.

As your gear changes, you swap single parts instead of replacing a whole set. These AOS 4 inch EVO 3D printed accessories keep your platform neat, protected, and ready for the next round of upgrades.