AOS RC 3.5 V5 3D Printed TPU Accessory For FPV Frames

Purpose Built 3D Prints For Your 3.5 V5

AOS RC 3.5 V5 3D printed accessories give your 3.5 inch frame a complete kit of practical TPU parts. The set focuses on real flying, not just looks, so every piece helps protect gear, simplify wiring, or improve usability on the bench. You spend less time fighting your build and more time flying it.

Instead of digging through random files that almost fit, you drop in a family of parts that match the frame layout. The result is a tidy setup that feels intentional from front to back. Your quad looks organized, and working on it becomes much faster.

What Comes In The Kit

This accessory pack covers the core needs of most 3.5 inch FPV pilots:

• FPV camera protector and shroud that shields the lens in front impacts

• Rear antenna mount options that hold VTX and receiver antennas at clean, repeatable angles

• Action camera style mount footprint sized for popular compact cameras

• Simple plates or brackets that support receiver and VTX units without flex

• Wire guides and strain relief that keep cables away from props and sharp edges

Each piece lines up with common hole spacing on the 3.5 V5 platform. You can reuse existing hardware in many spots, which keeps the build simple and light.

Built Around Real Flight Conditions

A 3.5 inch quad often flies close to obstacles, so crashes happen. These TPU parts keep antennas, cameras, and electronics away from prop paths and common impact zones. This layout reduces broken gear and keeps you flying the same rig for more packs.

The kit works for quick freestyle sessions, relaxed cruising, or light cinematic lines. You can push the quad hard, then still trust the mounts when you strap on an action camera for smoother footage.

Easy To Install, Easy To Upgrade

Mounting the parts stays straightforward. The geometry respects the AOS RC 3.5 V5 frame, so pieces sit where they should without strange angles. You bolt them on, route the wires, and see the layout fall into place.

As your setup evolves, you can still rely on the same AOS RC 3.5 V5 3D printed accessories kit. Swap antennas, change video hardware, or try a different action camera while keeping the overall structure and mounting points consistent. This gives you a neat, protected 3.5 inch platform that can grow with your flying.