AOS RC 4 Inch V5 3D Printed TPU Accessories For FPV Frames

AOS RC 4 Inch V5 3D Printed Accessories For Your Build

AOS RC 4 inch V5 3D printed accessories give your frame a flexible way to add protection and function. You choose each part on its own, so every piece on the quad has a clear purpose. This approach keeps weight under control and still covers the spots that take the hardest hits.

You do not rely on a fixed bundle that forces extra parts into your layout. Instead, you select prints that match your camera, antenna plan, and electronics stack. The result feels custom, clean, and easy to work on at the bench or in the field.

Choose Individual TPU Parts For Your 4 Inch V5

Every accessory prints in tough TPU and sells as a single item. You build your own set from options like:

• FPV camera guard and shroud that shield the lens during head on impacts

• Rear antenna mounts that hold VTX and receiver antennas at tidy, repeatable angles

• Action camera base that fits popular compact HD cameras for smooth flight footage

• VTX and receiver plates that keep boards from flexing or sliding in rough crashes

• Wire clips and strain relief parts that guide leads away from props and sharp carbon edges

You can start with one mount, then add more pieces as your gear or flying style changes. The shared spacing and design language keep everything aligned when you expand the build.

Made For Real Spots And Hard Sessions

A 4 inch V5 rig often flies through tight gaps, near branches, and close to concrete. Impacts will happen, so these TPU parts move sensitive gear away from obvious strike zones. The prints flex and absorb many small hits, which helps cameras, antennas, and wires survive longer.

This layout suits fast freestyle, bando sessions, and relaxed cruising at the park. You keep one trusted frame and tune props, filters, and camera settings instead of building a new quad for every mission.

Simple To Install And Easy To Update

Install time stays short. Each print follows the AOS RC 4 inch V5 geometry, so holes line up and hardware fits without odd spacers. You bolt the part on, check prop clearance, and you are ready to fly.

When your setup changes, you only swap the single prints that no longer match. With the right mix of AOS RC 4 inch V5 3D printed accessories you keep the same solid base frame while your electronics and layout evolve around it. Your quad stays neat, protected, and ready for the next pack.