AOS RC 5R V5 3D Printed TPU Accessories For Racing Frames

AOS RC 5R V5 3D Printed Accessories For Your Race Rig

AOS RC 5R V5 3D printed accessories give your race frame a flexible way to add function and protection. You buy each part on its own, so every piece on the quad has a clear purpose. This keeps your build light while you still shield the components that take the hardest hits on the track.

You do not have to commit to a fixed bundle that forces extra parts onto your build. Instead, you select single TPU prints that match your camera, antenna layout, and electronics stack. The result feels clean, intentional, and easy to service between heats.

Individual TPU Parts For The 5R V5 Racing Frame

Every accessory prints in tough TPU and sells as a separate item. You create your own combo from options like these.

• Low profile FPV camera guard and shroud that protect the lens in gate strikes

• Rear antenna mounts that hold VTX and receiver antennas at repeatable race ready angles

• Compact action camera base that fits popular lightweight HD cameras

• Slim VTX and receiver plates that stop boards from sliding during crashes

• Wire clips and strain relief parts that route leads away from props and sharp carbon edges

You can start with one camera guard, then add antenna or HD cam mounts as your race setup evolves. Shared spacing and a consistent design language help every new print line up with the parts already on the frame.

Built For Gates, Concrete, And Hard Impacts

A 5 inch racing frame spends its life near gates, poles, and concrete. Crashes are part of every session. These TPU pieces move sensitive parts away from common strike zones and help absorb many direct hits. Cameras stay aimed, antennas bend instead of snapping, and wires face fewer cuts and pulls.

The layout fits pure racing, fast practice sessions, and light freestyle between heats. You keep one trusted AOS RC 5R V5 frame and adjust props, tune, and rates instead of building a new quad for every track layout.

Quick To Install And Easy To Update

Install time stays short. Each print follows the AOS RC 5R V5 geometry, so holes line up and hardware fits without odd spacers or guesswork. You bolt the part on, check clearance around the props, and get back to flying.

When your gear changes, you only swap the single prints that no longer match your setup. With the right mix of AOS RC 5R V5 3D printed accessories you keep the same solid race frame while your electronics and layout grow with your skills. Your quad stays neat, protected, and ready for the next heat.