AOS RC 6 Inch V5 3D Printed TPU Accessories For FPV Frames

AOS RC 6 Inch V5 3D Printed Accessories For Your Long Range Build

AOS RC 6 inch V5 3D printed accessories give your long range frame a flexible way to add function and protection. You select each part on its own, so every piece on the quad has a clear job. This control keeps the build light while you still shield the components that see the hardest hits.

You do not have to buy a fixed bundle that includes parts you never use. Instead, you choose individual TPU prints that match your camera, antenna layout, and electronics stack. The result feels clean, planned, and easy to service in the field or at the bench.

Pick Individual TPU Parts For Your 6 Inch V5

Each accessory prints in tough TPU and sells as a separate item. You build your own setup from focused options.

• FPV camera guard and shroud that protect the lens during front impacts

• Rear antenna mounts that hold VTX and receiver antennas at neat, repeatable angles

• Action camera base that fits popular lightweight HD cameras for clear long range footage

• VTX and receiver plates that keep boards from sliding or flexing in crashes

• Wire clips and strain relief parts that guide leads away from props and carbon edges

You can start with one camera guard, then add antenna or action cam mounts as your needs grow. Shared spacing and a consistent style help every new print line up with the parts already on the frame.

Built For Distance, Wind, And Rough Terrain

A 6 inch rig often flies far, deals with wind, and lands in rough spots. Crashes and tumbles will happen. These TPU pieces move sensitive parts away from common strike zones and help absorb many direct hits. Cameras stay aimed, antennas bend instead of snapping, and wires face fewer cuts.

The layout works for long range exploration, mountain dives, and smooth cruising. You keep one trusted AOS RC 6 inch V5 frame and tune props, filters, and camera settings instead of building a new quad for every mission.

Fast To Install And Easy To Update

Install time stays short. Each print follows the AOS RC 6 inch V5 geometry, so holes line up and hardware fits without odd spacers. You bolt the part on, confirm clearance, and head back into the air.

When your gear changes, you only swap the single prints that no longer match. With the right mix of AOS RC 6 inch V5 3D printed accessories you keep the same solid base frame while your electronics and layout evolve with your flying. Your quad stays neat, protected, and ready for the next long range pack.