AOS RC 7 Inch v5 3D Printed TPU Accessories For FPV Frames

AOS RC 7 Inch V5 3D Printed Accessories For Your Long Range Build

AOS RC 7 inch V5 3D printed accessories give your all new 7 inch frame a flexible way to add function and protection. You buy each part on its own, so every piece on the quad has a clear role. This control keeps the build light while you still cover the components that matter most on a long range rig.

You do not have to purchase a fixed kit filled with parts you will never bolt on. Instead, you select individual TPU prints that match your camera, antenna layout, and electronics stack. The result feels clean, planned, and easy to work on at the bench or out in the field.

Choose Individual TPU Parts For Your 7 Inch V5

Every accessory prints in durable TPU and is sold as a separate item, not as a bundle. You build your own setup from focused options like these.

• FPV camera guard and shroud that protect the lens during front impacts

• Rear antenna mounts that hold VTX and receiver antennas at neat, repeatable angles

• Action camera base that fits popular compact HD cameras for clear long range footage

• VTX and receiver plates that keep boards from sliding or flexing in rough crashes

• Wire clips and strain relief parts that guide leads away from props and sharp carbon edges

You can start with a simple camera guard, then add antenna or action cam mounts as your build evolves. A shared spacing and consistent design style help new prints line up with the parts already on the frame.

Built For Distance, Wind, And Rough Ground

A 7 inch V5 rig often flies far from home, deals with wind, and lands in uneven terrain. Crashes and tumbles are part of that style of flying. These TPU pieces move sensitive components away from common strike zones and help soften many direct hits. Cameras stay aimed more often, antennas bend instead of snapping, and wires see fewer cuts and pulls.

This layout works for long range cruising, ridge and mountain dives, and smooth exploration flights. You keep one trusted AOS RC 7 inch V5 frame and tune props, filters, and camera settings instead of building a new quad for every mission.

Quick To Install And Simple To Update

Install time stays short. Each print follows the AOS RC 7 inch V5 geometry, so holes line up and hardware fits without odd spacers. You bolt the part on, confirm prop clearance, and get back in the air.

When your gear changes, you only swap the single prints that no longer match your setup. With the right mix of individual AOS RC 7 inch V5 3D printed accessories you keep the same solid base frame while your electronics and layout grow with your skills. Your quad stays neat, protected, and ready for the next long range pack.