AOS RC EVO 3.5 3D Printed Accessory – Camera, Antenna & GoPro Mounts

3D Printed Accessory Kit For Your EVO 3.5 Build

AOS RC EVO 3.5 3D printed accessories give your 3.5 inch EVO frame a complete and matched set of TPU parts. The kit focuses on mounts and guards that shield your components, simplify wiring, and keep everything aligned on AOS style EVO 3.5 layouts. You get a cleaner build, better protection in crashes, and a quad that looks as sharp as it flies.

Instead of mixing random prints that almost fit, you install a coordinated family of parts that work together on one platform. This approach saves time, reduces guesswork, and helps you reach a professional finish faster.

What You Get In The Kit

This accessory set targets the real needs of 3.5 inch FPV pilots who fly proximity, freestyle, or light cinematic lines:

• Front FPV camera protector and shroud that adds impact protection and helps keep the lens clear

• Rear antenna mounting options that suit common VTX and receiver antenna styles

• Action camera style mount footprint that supports popular small format cameras

• Plates or brackets that hold receiver and VTX units firmly in place

• Wire guides and strain relief parts that reduce cable fatigue and broken solder joints

Because the parts follow a single design language, clearances line up and hardware reuse stays simple. You avoid awkward angles, crooked mounts, and props clipping sensitive gear.

Built For Real FPV Flying

Space on a 3.5 inch quad is tight, so every millimeter matters. These parts follow typical EVO 3.5 geometry and keep antennas, camera housings, and electronics away from prop arcs and obvious impact zones. This layout helps reduce crash damage and keeps you in the air longer between repairs.

The setup supports playful freestyle sessions and smooth cruising. You can explore a spot, practice new tricks, or capture relaxed footage without swapping frames or changing your layout.

Simple Installation And Future Upgrades

Installation stays straightforward. The parts use common hardware and hole spacing that match the AOS EVO 3.5 ecosystem, so you can bolt them on with minimal adjustment. As your electronics change, you still rely on the same AOS RC EVO 3.5 3D printed accessories by swapping individual mounts or changing antenna styles.

If you want a neat, protected, and consistent 3.5 inch platform, this accessory kit gives you a practical path to that result.